Anyone got a carb balancer?

[bikemonkey]

As above, has anyone got a carb balancer for 4 cylinders? I'd like to borrow it
Adapters for the NC30 would be amazing too.

Plus if you're not too far and willing, a bit of help wouldn't go a miss either

Thanks in advance.

[speedy231278]

Supposedly you don't need specific adapters for the NCs as they use the same size vac take-off points as the other models. At least, that's what Carbtune say, so I'll be miffed if I find it doesn't fit when I do mine... lol

[V4beermonster]

Take carbs off and balance by eye using the 3 holes in the Venturi

[Neosophist]

Corret, the NC30 requires screw in type take-off adapters.

There are two common types of adapter threads used on most bikes 5mm and 6mm. I cant remember which one fits the NC30 but 4 of each type come with the mogan carb-tune when you buy it so you wont have any proeblems using.

[scotjell]

If using it make sure you get a good tool for getting in there to adjust!!!

[bikemonkey]

Might get a right angled screwdriver if need be, or just blow torch and bend one

[scotjell]

http://www.google.co.uk/products/catalo ... CEQQ8wIwAw

[bikemonkey]

Sod that, £16 or "modify" an old one I don't like? I know which I'd choose.

[scotjell]

Just remember its the internals of these that turn and not the driver itself there is a shaft inside. Stops your pinkys and the back of your hand looking like the elephant man.

[porndoguk]

its and m5 thread for the vacuum points, sod fancy screwdrivers if you got small enough hands use a marigolds glove and a 7mm socket and use your fingers, thats how i do it its fiddly but doable