advice needed (NC 30/35 loom differences)

[mo haggs]

Cool pm me your address and i'll get it in the post,
I'll pay pal you the cost of postage.

I have a 35 left switchgear.

Any thoughts on were i might find the rad fan connector on the 35 loom?

[Drunkn Munky]

No its fine dont worry about the postage, if you can wait till friday i'll get the misses to do it through work.

Ive got a scrap 35 (i think) loom in the loft that might still have the rad connector on it, if it has i'll sent it aswell. You want the loom end not the fan end yes? if that makes sense lol

[mo haggs]

No its fine dont worry about the postage, if you can wait till friday i'll get the misses to do it through work. Cool

Ive got a scrap 35 (i think) loom in the loft that might still have the rad connector on it, if it has i'll sent it aswell. You want the loom end not the fan end yes? Thats right, but i can't even see any wires were the connector has been removed

[mo haggs]

Just a wee update. Start/kill switch has been replaced withe correct unit (thanx DM)
i found the wires that the radfan plug had been cut off (taped up inside the loom) and have replaced the plug (again thanx DM)

So all i have to do now is swap the nc30 lower rad that i have for an nc35 lower rad

[Drunkn Munky]

Do you mean rad fan? May have one of them too :)

[mo haggs]

Lol, fancy a swap?

We'll be swaping wives soon

[Drunkn Munky]

lol let me dig it out and check first, i never actually fitted it to my rvf so cant be certain it is a rvf one but will grt up in the loft later and check

[Drunkn Munky]

Mo, not sure if this is 30 or 35

DSC04425.JPG

DSC04426.JPG

[mo haggs]

think Thats a 35 unit, just what i need.
I'll get som pics up of the 30 unit i have here and you can check it out.

[mo haggs]