Official Dyno Day --- Interest?
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Settled in member
- Posts: 235
- Joined: Wed Apr 22, 2009 2:10 pm
Re: Official Dyno Day --- Interest?
Ive hit yet another problem on this Im afraid guys..
Ive noticed my tyre tread is looking a bit low on the rear, on closer inspection, its almost non existant and so therefore Illegal to use on the road!
So, unless I can find £120 by Friday to have a new tyre fitted to my spare Rim (I want to put it back to 18" original, lol) I wont be able to make it!
Fingers crossed, Im in talks with SWMBO's parents on the money issue. LOL
Ive noticed my tyre tread is looking a bit low on the rear, on closer inspection, its almost non existant and so therefore Illegal to use on the road!
So, unless I can find £120 by Friday to have a new tyre fitted to my spare Rim (I want to put it back to 18" original, lol) I wont be able to make it!
Fingers crossed, Im in talks with SWMBO's parents on the money issue. LOL
-
- Site Supporter
- Posts: 1670
- Joined: Tue Apr 29, 2008 8:56 pm
- Bike owned: NC30 Road, SV650 Race
- Location: Hampshire, Wichester
Re: Official Dyno Day --- Interest?
mate dont worry, iv been riding on diablo supercorsas that the conplete right side is slick! no one will notice, If you really need iv got an 18" 092 you could borrow if you cover the postage cost their and back but its a bit square
-
- Settled in member
- Posts: 235
- Joined: Wed Apr 22, 2009 2:10 pm
Re: Official Dyno Day --- Interest?
I was going to Fit BT92's anyway! but TBH, I might aswell get a new one rather than go through this hasle just the other side of christmas. Ive just come off a BT92 and think they are great tyres for the NC30, but once they have started to square off, they go bad very quickly. i would of said mine was fine about 300 miles ago!?! Now it is squared off probably to the extent the bike would stand itself up on them, lol! And the handling really really went bad once it had squared off. I actually was considering getting rid of it because i just didn't enjoy riding it anymore on the squarer tyre!
Thankyou very very much for your offer though, but I'll try and get a new one in!
Thankyou very very much for your offer though, but I'll try and get a new one in!
-
- Regular Member
- Posts: 893
- Joined: Wed Apr 30, 2008 7:39 pm
Re: Official Dyno Day --- Interest?
Well seeing as neither I or my wife can ride atm I think we're going to have to back out. :-/
Druid
Druid
-
- Familiar Member
- Posts: 260
- Joined: Thu May 01, 2008 12:26 am
- Bike owned: some ZXR400's, ty175, mz ts125
- Location: Hereford
Re: Official Dyno Day --- Interest?
I may pop along if i can cobble a functioning bike together
- Matchlessman
- Familiar Member
- Posts: 261
- Joined: Fri May 02, 2008 12:29 pm
- Location: Stroud, Glos
Re: Official Dyno Day --- Interest?
Im not going to be able to make it. Ive been working in London since i got back from Europe and havent even touched the triumph.
Also, the way works going, im not home much for the next month so really need to spend some time with my girlfriend.
Also, the way works going, im not home much for the next month so really need to spend some time with my girlfriend.
Too many bikes, so little time!
-
- Settled in member
- Posts: 235
- Joined: Wed Apr 22, 2009 2:10 pm
Re: Official Dyno Day --- Interest?
Just spoken to kevin at Projex, hes all set and ready to get this Dyno Day underway on Saturday. Thinking about it, I can make it for definate now, it just depends wether the bike is in the back of a van or not? LOL.
Should be good, see you all there.. (those of you left that are coming! ha ha!) i should be there for about 9.30am or earlier..
Should be good, see you all there.. (those of you left that are coming! ha ha!) i should be there for about 9.30am or earlier..
-
- Senior Member
- Posts: 1218
- Joined: Tue Apr 29, 2008 9:13 pm
- Bike owned: ftr223 650 bros
- Location: Surrey
Re: Official Dyno Day --- Interest?
I only asked as I thought you were on 18" rims, but I see you are on 17"CRM wrote:got either a pair of supercorsa pro's or diablo corsa's
Was keeping one pair for the 916, but now i found a set of gold 5 spoke early magnesiums from a 955, i have to use a 190 as its a 6" rim, so both sets are for the RC
was going to go with the pro's just because i dont ride it in a monsoon and they grip like a bastard
I fitted Dragon supercorsa pro street on 5.5" kit rims as they are 178mm wide and clear the swinging arm.
They ride pretty good too.
I thought 6" rims will take 180 or 190 tyres according to the tyre charts, but there will always be a "best" fitted profile.
Dave.
- Riley
- Site Supporter
- Posts: 228
- Joined: Wed Apr 30, 2008 7:53 pm
- Location: Gloucester
Re: Official Dyno Day --- Interest?
I'm really sorry but I'm going to have to pull out, my fiance is off on her Hen weekend, which I thought would be fine as my Mum could have looked after my daughter for the morning but I've got to go for my final suit fitting on the saturday it turns out. Shame, I was looking forward for a butty and to see what the bike was pushing out as well as meeting a few more members from here.
Need any used Nc30 parts? Want to fit a Ducati front end to your Nc30? If so give me a shout.
- paul nc 24
- Site Supporter
- Posts: 114
- Joined: Wed Feb 25, 2009 4:32 pm
- Bike owned: 2000 R1
- Location: WREXHAM
Re: Official Dyno Day --- Interest?
just how many of us are still turning up on saturday? out of nearly 30 a month ago theres only a few still intrested me thinks 
dont know if i can make it as i cant find a matching pair of sock's he he he

dont know if i can make it as i cant find a matching pair of sock's he he he
