Oil levels? How to gauge accurately RVF400

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
Smitizen
Settled in member
Posts: 36
Joined: Thu May 14, 2009 3:13 am

Oil levels? How to gauge accurately RVF400

Post by Smitizen » Tue Aug 18, 2009 1:21 am

As the title states apart from dip stick checking how else can oil levels be checked?
The was NO oil on my dip stick last night so i topped it up with a litre and was checking every 200ml by putting the dip stick in to check it.
This morning i get to my bike and there's about 200mls + on the ground and tonight i'm going to clean out what's stuck inside the fairing.

So what's the best method of checking?
Is it best to check your levels hot or cold?
And how much oil do these things hold?

Cheers! :grin:

User avatar
viper_biker
Moderators
Moderators
Posts: 1798
Joined: Sun Apr 06, 2008 11:25 am
Bike owned: VFR400RR, CBR1000RR6
Location: Belfast, Norn Iron
Contact:

Re: Oil levels? How to gauge accurately RVF400

Post by viper_biker » Tue Aug 18, 2009 1:32 am

Cold engine,
Bike upright,
Do not screw in the dip-stick.
Ducati 916, not worth a carrott

Smitizen
Settled in member
Posts: 36
Joined: Thu May 14, 2009 3:13 am

Re: Oil levels? How to gauge accurately RVF400

Post by Smitizen » Tue Aug 18, 2009 2:05 am

Shit is STILL leaking! Ferk.
I'll check the level again before i ride tonight.

How much do these bikes hold?

User avatar
CMSMJ1
Moderators
Moderators
Posts: 7152
Joined: Thu May 01, 2008 9:42 am
Bike owned: NC30-No9
Location: Chesterfield, United Kingdom

Re: Oil levels? How to gauge accurately RVF400

Post by CMSMJ1 » Tue Aug 18, 2009 8:25 am

You need to stop it leaking rather than keep topping up.

It holds 2.4l with a filter change I think.
IMPERATOR REX ANGLORUM

The V4 is the law..

NC30 - No9 - my old mate

Smitizen
Settled in member
Posts: 36
Joined: Thu May 14, 2009 3:13 am

Re: Oil levels? How to gauge accurately RVF400

Post by Smitizen » Tue Aug 18, 2009 11:14 pm

It's only leaking because it's too full. Whoops.

User avatar
CMSMJ1
Moderators
Moderators
Posts: 7152
Joined: Thu May 01, 2008 9:42 am
Bike owned: NC30-No9
Location: Chesterfield, United Kingdom

Re: Oil levels? How to gauge accurately RVF400

Post by CMSMJ1 » Tue Aug 18, 2009 11:16 pm

lol...fair enough.

Where from though?

If it is too full you'll get a lot of blowback into the airfilter out of the crankcase breather so be ready to change the filter sooner rather than later ;)
IMPERATOR REX ANGLORUM

The V4 is the law..

NC30 - No9 - my old mate

Smitizen
Settled in member
Posts: 36
Joined: Thu May 14, 2009 3:13 am

Re: Oil levels? How to gauge accurately RVF400

Post by Smitizen » Wed Aug 19, 2009 1:46 am

Well that's AWESOME. Bugger. :down:
Um not entirely sure where but it had a full night to really leak out before i rode it.
Since then it's only tiny drips which may even just be from the underbelly of the fairing where there's a whole lot of oil sitting.
Didn't get a chance to clean it out last night (bloody women) but i'll suss it out this evening for sure.

Is there only "bad" spots for overflow to leak out of?

Post Reply