Got my bike a pressie, but how do I fit it? (Rad overflow)

Post by **DAC** » Mon Dec 08, 2008 10:19 am

Just to finish off, I found this picture on my old PC at the weekend. It came from this forum many moons ago, don't know who posted it, so can't pass on any royalties.

Regards,

Dave.

oliherst · Post by **oliherst** » Mon Dec 08, 2008 3:54 pm

Hahaha I just want to say, not only is that very helpful but it is also TOTALLY AWESOME :D :D

Post by **jowyvfr** » Wed Dec 10, 2008 11:26 am

Pretty obvious who posted that originally......

:D

oliherst · Post by **oliherst** » Mon Dec 15, 2008 4:30 pm

hahahahaaaaaa ok call me dumb, but I totally missed the point of this mod, and have just worked it out.

For ages I was looking at my bike and this thread and my haynes manual trying to work out why I couldn't work it out.

The idea behind this mod is to bypass the reserviour under the seat isn't it?

Post by **Spike16** » Mon Dec 15, 2008 4:39 pm

not quite bypass, more like replace, it also means you dont have to remove the tail to check, refill coolant and...err its says HRC

Got my bike a pressie, but how do I fit it? (Rad overflow)

Re: Got my bike a pressie, but how do I fit it? (Rad overflow)

Re: Got my bike a pressie, but how do I fit it? (Rad overflow)

Re: Got my bike a pressie, but how do I fit it? (Rad overflow)

Re: Got my bike a pressie, but how do I fit it? (Rad overflow)

Re: Got my bike a pressie, but how do I fit it? (Rad overflow)