NC24 Specalists?

[christ044]

Thanks mate, ill keep the web address but i think iv found someone who can make them up using the old ones as a pattern, might take him a little while (side job!) But then im rebuilding the whole bike!

[Neosophist]

ah no worries, if you need anything else let me know.

The collector on my NC24 atm has the pipes cut off which the front two pipes originally went into and replace with Stainless ones and the rear downpipes have been cut and a piece of stainless tubing welded in between, so you can remove the collector without takign the engine out :)

Handy when taking the sump off.

[christ044]

Thanks Mate.

Must admit i did think about having the rears made so instead of sliding into the actual collector, they wouls slide into tubes coming out of the collector like you say making it easier to do any underside work.