RVF 400 Fan Switch

chuchu20 · Post by **chuchu20** » Mon Mar 19, 2012 9:26 am

Hey guys

Does anyone know how to put a fan switch on an RVF 400? Done it once before on a cbr250, just connect the fan switch to ground. Cant seem to find out how to do it on the RVF. Thanks

phil x · Post by **phil x** » Mon Mar 19, 2012 10:24 am

Yep, the fan is permanently live (off the ignition), use a switch to earth & complete the circuit.

Phil

arsey30 · Post by **arsey30** » Mon Mar 19, 2012 11:04 am

Fit a fully insulated piggy back spade terminal to save cutting into the existing wiring.

chuchu20 · Post by **chuchu20** » Tue Mar 20, 2012 5:31 am

Where did you mount the spade connector too? Is it to the bit the hangs off the left of the bottem rad? The fan switch I think it's called?

arsey30 · Post by **arsey30** » Tue Mar 20, 2012 8:08 am

The green wire goes to one side of the new manual switch and the piggy back spade pushed onto the existing rad fan switch.
The original fan switch wire spade [black shrouded] pushes onto the piggy back connector.
The wires are hanging off in the picture to show more clearly their fitting, picture is new spade removed from rad fan switch.

Post by **CRM** » Tue Mar 20, 2012 8:56 am

dont cut the red wire

chuchu20 · Post by **chuchu20** » Tue Mar 20, 2012 9:16 am

All good got it all to work tonight thanks

RVF 400 Fan Switch

RVF 400 Fan Switch

Re: RVF 400 Fan Switch

Re: RVF 400 Fan Switch

Re: RVF 400 Fan Switch

Re: RVF 400 Fan Switch

Re: RVF 400 Fan Switch

Re: RVF 400 Fan Switch