wheel compatability
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
hannakournikova
- Site Supporter
- Posts: 769
- Joined: Wed Apr 30, 2008 6:46 pm
- Bike owned: NC30, NC35 & SP2
- Location: Belfast, Northern Ireland
wheel compatability
Royster asked this before, but nothing was conclusive.
Can an NC29 rear wheel be fitted??
Can an NC29 rear wheel be fitted??
-
hannakournikova
- Site Supporter
- Posts: 769
- Joined: Wed Apr 30, 2008 6:46 pm
- Bike owned: NC30, NC35 & SP2
- Location: Belfast, Northern Ireland
Re: wheel compatability
bump!!
-
amorti
- Regular Member
- Posts: 957
- Joined: Sun May 18, 2008 4:51 pm
- Bike owned: CB-1, MSX125
- Location: Gibraltar
Re: wheel compatability
Fitted... to what?
I can tell you that with spacers a 29 wheel fits a CB-1 in terms of physically fits and the brake works, but that the chain run will be off. I suspect the wheel alignment will therefore equally be off line. And that it is a swine / not possible to try and get right, so I ended up just changing the whole rear end on my CB. The two swingarms are the same width at the engine, but I think the extra width for the wider wheel is added on the right.
Complicated to explain, but basically an nc29 wheel won't fit in a cb-1, or it will, but it won't line up right.
I think you would have more luck with a cbr600f2 wheel, I believe that fits a cb-1, so should fit your 400sf too?
I can tell you that with spacers a 29 wheel fits a CB-1 in terms of physically fits and the brake works, but that the chain run will be off. I suspect the wheel alignment will therefore equally be off line. And that it is a swine / not possible to try and get right, so I ended up just changing the whole rear end on my CB. The two swingarms are the same width at the engine, but I think the extra width for the wider wheel is added on the right.
Complicated to explain, but basically an nc29 wheel won't fit in a cb-1, or it will, but it won't line up right.
I think you would have more luck with a cbr600f2 wheel, I believe that fits a cb-1, so should fit your 400sf too?