Swingarm/Proarm Nut

[Spotswood]

As the title says...can someone advise what size the gigantic nut is for the swingarm? You know the one...castle nut on one end and gigantic nut on the other end by the rear set...it would save me a drive home if anyone can answer..thanks in advance! :D

[elrikos]

46mm if i remember correctly

[Neosophist]

I thought it was 38mm?

Or am I thinking of a different nut

[elrikos]

if its the one i'm thinking of (the one on the sprocket side of the rear hub) then i think its 46mm. hold on i'll go and have a measure ( i am that sad!!)

[elrikos]

yep for the nc30 its 46mm.

[Spotswood]

OK if anyone is still up (it's only 330pm here :D ) I'm confused elrikos...do you mean the axle nut? Beacuse I'm talking about the where the swingarm bolts through the frame right by the counter shaft sprocket and 46mm seems a bit too large for that but just right for the axle.

[Spotswood]

I guess everyone is passed out so I'm going to try the 38mm...note to self...keep reciept this time

[Neosophist]

I guess everyone is passed out so I'm going to try the 38mm...note to self...keep reciept this time

go for the 38mm :) (thats the one that needs 165nm of torque)

[CMSMJ1]

+1 with Neosophist..

the other guys are getting their hubs and swingarms mixed up...

[Spotswood]

Never made it to the store in the end but I had a look at the nut last night and it looks closer to a 27mm? If anyone can check again to see what size socket I need that would be very helpful