NC30 Speedo not working

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
biga1
Settled in member
Posts: 19
Joined: Wed Jul 27, 2011 9:54 am
Bike owned: UK NC30

NC30 Speedo not working

Post by biga1 » Mon Aug 01, 2011 10:36 am

Hi, My speedo is not working ? Any ideas or advice + Parts ? Just got a NC30 so starting off!
Cheers
Alex
Top
amorti
Regular Member
Posts: 957
Joined: Sun May 18, 2008 4:51 pm
Bike owned: CB-1, MSX125
Location: Gibraltar

Re: NC30 Speedo not working

Post by amorti » Mon Aug 01, 2011 10:41 am

biga1 wrote:Hi, My speedo is not working ? Any ideas or advice + Parts ? Just got a NC30 so starting off!
Cheers
Alex
Speedo cable is first and most likely. Disconnect at the back of the speedo and see if you can turn the wheel and hold the top end still. If yes it's broken - replace.
Top
magg
Senior Member
Posts: 1915
Joined: Mon Sep 20, 2010 11:55 pm
Bike owned: VFR400
Location: Blue Mountain NSW Australia

Re: NC30 Speedo not working

Post by magg » Mon Aug 01, 2011 10:48 am

Is drive cable ok? Also check the drive unit on the gearbox sprocket cover, particularly the plastic coupling on the end of the sprocket bolt. It could be missing or broken. If the above are ok then try driving the speedo with battery powered drill to see if it reads.
Top
biga1
Settled in member
Posts: 19
Joined: Wed Jul 27, 2011 9:54 am
Bike owned: UK NC30

Re: NC30 Speedo not working

Post by biga1 » Tue Aug 02, 2011 11:33 am

Thanks guys, Checked the cable and ity was snapped near the joint at the bottom - so ordered a new one cheers
Top
Post Reply

Return to “Honda - Workshop”