OIL PRESSURE SWITCH

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
GIXERMARK0
Settled in member
Posts: 29
Joined: Sun Jul 10, 2011 1:43 pm

OIL PRESSURE SWITCH

Post by GIXERMARK0 » Fri Jul 15, 2011 7:27 pm

HI
LOOKING TO CHANGE THE OIL PRESSURE SWITCH

unfortunatly i dont have a workshop book yet so could some one point me in the correct direction to where it is on the engine
i asked at my local Honda dealers and they could not find it on the micofish

cheers mark
Top
hardnutdvd
Regular Member
Posts: 608
Joined: Fri Jan 01, 2010 8:50 pm
Bike owned: RVF400 NC35
Location: Bedford, Bedfordshire

Re: OIL PRESSURE SWITCH

Post by hardnutdvd » Fri Jul 15, 2011 7:36 pm

from the Haynes
"the oil pressure switch is screwed into the crankcase between the cylinders, and is accessed by removing the lower fairing.
Pull the rubber cover off the switch and remove the screw securing the wiring connector.
with the ignition switched ON, earth (ground) the wire on the crankcase and check that the warning light comes on. If the light comes on, the switch is defective and must be replaced."
Top
GIXERMARK0
Settled in member
Posts: 29
Joined: Sun Jul 10, 2011 1:43 pm

Re: OIL PRESSURE SWITCH

Post by GIXERMARK0 » Fri Jul 15, 2011 9:14 pm

hi
thanks for the info
but it you ground the wire and the light comes on then the wireing and bulb is ok
my oil light comes on at tick over when warm so it could be the oil but wanted to change the switch just in case its faulty
Top
Post Reply

Return to “Honda - Workshop”