How to transport a bike in a van? advice/instructions please

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
ramonlv
Site Supporter
Site Supporter
Posts: 36
Joined: Fri Jul 09, 2010 11:41 pm
How to transport a bike in a van? advice/instructions please

Post by ramonlv »

Hi,

I need to move my non starting nc30 quite a distance so I thought it would be best to hire a van and do it. But I have never done this so could do with some advice, mainly being what harnesses do I need and where to get them from. But if you could walk me through the whole process I would appreciate it.

Thanks,

Ramon
User avatar
Smev
Site Supporter
Site Supporter
Posts: 858
Joined: Tue Apr 29, 2008 8:54 pm
Bike owned: NC30 of course
Location: The Mighty Cornwall :-)
Re: How to transport a bike in a van? advice/instructions pl

Post by Smev »

I've used paddock stands in the past and some ratchet strops.

Pop the bike in the Front wheel in first.

Put the rear stand in only - then use a ratchet strop on each side through the pillion pegs or subframe and tighten it down to secure points on the van floor - compressing the suspension slightly.

For the front end I used a couple more straps around the forks just above the yokes and again tied them off to secure points on the van floor.

I gave it bit of a wobble to try to move it and it didn't.

At points along the route I would stop and check it was still secure. Did 250 miles like this and no problems. :grin:

Hope this helps you out?
Mister Donut Rep NC30
User avatar
porndoguk
Site Supporter
Site Supporter
Posts: 3293
Joined: Wed Jun 16, 2010 11:17 pm
Bike owned: NC30
Location: Middle England
Contact:
Re: How to transport a bike in a van? advice/instructions pl

Post by porndoguk »

Smev wrote:I've used paddock stands in the past and some ratchet strops.

Pop the bike in the Front wheel in first.

Put the rear stand in only - then use a ratchet strop on each side through the pillion pegs or subframe and tighten it down to secure points on the van floor - compressing the suspension slightly.

For the front end I used a couple more straps around the forks just above the yokes and again tied them off to secure points on the van floor.

I gave it bit of a wobble to try to move it and it didn't.

At points along the route I would stop and check it was still secure. Did 250 miles like this and no problems. :grin:

Hope this helps you out?
+1, Only ever used the side stand method, i also cable tie the front brake, and stick it in gear,

couple of rachet straps jobs a good en,

my van has little lugage hooks everywhere which come in VERY handy.
NC30 & NC23 33BHP Restrictors For Sale
£25 Inc P&P and donation to 400GB PM for more details


http://www.bikerstraining.com

Like us on Facebook for more information - First Bike on Scene - Emergency Response Skills - UK
ramonlv
Site Supporter
Site Supporter
Posts: 36
Joined: Fri Jul 09, 2010 11:41 pm
Re: How to transport a bike in a van? advice/instructions pl

Post by ramonlv »

That's great news, thanks. I have the paddock stand already so just need the straps. It's making sense though so thanks a lot

Post Reply