honda parts question (non v4)

Post by **mo haggs** » Wed Jun 08, 2011 11:57 pm

what other bikes used the same clutch master cylinder as a 98 firestorm?

Post by **Cru Jones** » Thu Jun 09, 2011 1:30 am

Looks very similar to the older 1000rr and SP1/SP2 master cylinders.

Post by **Cammo** » Thu Jun 09, 2011 1:57 am

I reckon it would be similar to an rvf m/c - same calipers.

Post by **Cru Jones** » Thu Jun 09, 2011 5:54 am

Cammo wrote:I reckon it would be similar to an rvf m/c - same calipers.

He's asking about the clutch m/c not the brake.

Post by **Cammo** » Thu Jun 09, 2011 6:16 am

Fair point. lol

Post by **CRM** » Thu Jun 09, 2011 7:19 am

The VFR800 could be an option, if you can get me a pic (i sold my firestorm) perhaps the RC30 too

amorti · Post by **amorti** » Thu Jun 09, 2011 8:51 am

Is it a 1/2" master cylinder? Probably same as VFR800 then.

Post by **Neosophist** » Thu Jun 09, 2011 11:06 am

from memory I think most of them are the same size piston diameter (13mm?) (apart from the fluid container that changes design) on pretty much most of the 90's Honda bikes...

Post by **mo haggs** » Thu Jun 09, 2011 4:03 pm

thanx guys, most of the honda m/c's have the box type reservoir. the 98 firestorm had a remote res - the sp1 used the same set up but its silly money to buy sp1 parts (purely because they came off an sp1).

i bought a "complete" firestorm m/c assy but the knob i bought it from took off the res and the wee plastic connecter and i cannot get the parts to replace them anywere unless i buy an overpriced sp1 "complete" assy

amorti · Post by **amorti** » Thu Jun 09, 2011 5:35 pm

mo haggs wrote:thanx guys, most of the honda m/c's have the box type reservoir. the 98 firestorm had a remote res - the sp1 used the same set up but its silly money to buy sp1 parts (purely because they came off an sp1).

i bought a "complete" firestorm m/c assy but the knob i bought it from took off the res and the wee plastic connecter and i cannot get the parts to replace them anywere unless i buy an overpriced sp1 "complete" assy

Just a thought - could it be the same connector as used in a nissin brake master?

honda parts question (non v4)

honda parts question (non v4)

Re: honda parts question (non v4)

Re: honda parts question (non v4)

Re: honda parts question (non v4)

Re: honda parts question (non v4)

Re: honda parts question (non v4)

Re: honda parts question (non v4)

Re: honda parts question (non v4)

Re: honda parts question (non v4)

Re: honda parts question (non v4)