Coerce Rearsets Question

Post by **Cru Jones** » Wed Mar 16, 2011 6:44 pm

So, I got a set used and they're missing the spacers that go behind them. You know, the ones in the pic below. Can someone please measure their spacers, so I know what I need to buy from the industrial supply place? Yes, I know I can just buy a bunch of M8 washers, but I'd prefer just to have a properly sized spacer if possible.

Thanks.

Post by **CMSMJ1** » Wed Mar 16, 2011 8:28 pm

Why not get yourself some washers, space them out as you like it - and the buy a spacer to match?

Post by **Cru Jones** » Wed Mar 16, 2011 8:39 pm

CMSMJ1 wrote:Why not get yourself some washers, space them out as you like it - and the buy a spacer to match?

Well, I could do that or I could just find out what size spacer it is from someone who already has the stock Coerce spacers.

Post by **uber pikey** » Wed Mar 16, 2011 8:50 pm

I think you should buy a lathe, turn some spacers out and then let everybody know that you have a certain size spacer, oh and stop being selfish lol

Post by **Cru Jones** » Wed Mar 16, 2011 9:33 pm

uber pikey wrote:I think you should buy a lathe, turn some spacers out and then let everybody know that you have a certain size spacer, oh and stop being selfish lol

Sadly, my access to such a lathe won't exist soon as I'm moving away from my good friend that does that sort of stuff.

Post by **Hadies** » Wed Mar 16, 2011 9:39 pm

They look like the same spacers you get with SES rearsets. If you can't get dimensions from here then I suppose you could try getting in touch with SES.

Post by **Cru Jones** » Wed Mar 16, 2011 11:35 pm

Hadies wrote:They look like the same spacers you get with SES rearsets. If you can't get dimensions from here then I suppose you could try getting in touch with SES.

I wouldn't worry about it. If nobody posts up in the next few days then I'll just figure it out via CMSMJ1's method.

Post by **Drunkn Munky** » Wed Mar 16, 2011 11:45 pm

Rearset spacers are usually 10mm thick

Post by **porndoguk** » Wed Mar 16, 2011 11:52 pm

just buy some alloy rod, 20mm dia etc, drill and cut to required size

Post by **Cru Jones** » Thu Mar 17, 2011 12:15 am

porndoguk wrote:just buy some alloy rod, 20mm dia etc, drill and cut to required size

Actually, I found a site that just makes al spacers, aptly named 'aluminum-spacers.com.' So, job done.

Coerce Rearsets Question

Coerce Rearsets Question

Re: Coerce Rearsets Question

Re: Coerce Rearsets Question

Re: Coerce Rearsets Question

Re: Coerce Rearsets Question

Re: Coerce Rearsets Question

Re: Coerce Rearsets Question

Re: Coerce Rearsets Question

Re: Coerce Rearsets Question

Re: Coerce Rearsets Question