so it's started this morning.

[royster81]

over the past couple of days i've spent a lot of it thinking about my bikes, the parts i have in the garage and what i'm doing with them.

it didn't take long for me to realise i have alot of bits not fitted to bikes just sitting in boxes in the loft, i keep saying ,2i'll have to get around to fitting that" and "i'll hold off fitting that until...."

well this morning i thought it's a good a morning to start fitting bits ( albeit a cold one) and what better to start with that the HRC bits i have.

firt off the HRC catch tank i got from yahoo over a year ago. it was on my track bike but it's now sold so i better fit it to something.....

it's not 100% fitted yet but nearly there .... and you wouldn't even know it was there.


next up the HRC spec carbs,HRC oil cooler and whatever else i find up there.

and the things i don't need i'm going to sell. no point having them it i'm not using them.

[Drunkn Munky]

Excellent, finally the castrol bike is getting the HRC treatment it deserves

Are you going full on HRC with the carbs/intake setup? ie no filter.

[royster81]

yep , it's all sitting in a box cause it was taken off the track bike before it was sold. sitting there doing nothing so it's all getting fitted.

[Drunkn Munky]

Good to hear, so what other goodies you got planned for her then?

[royster81]

off the top of my head i remember the HRc oil cooler and HRC spec carbs, i have 2 pairs of heads i've wanted to get ported ( there i go again, i've been wanting to do alot but never get around to it ) so i'll look into getting those done and fitted and the other set was for the motor i was building ( )

i have a stock system, a sansei system, i think i have an ethos too, 2 pairs of forks, HRC bottles and brake res, i think i have lights,mirrors,uncut undertrays,stock subframes,engine cases .....thats about all i can remember but as i open boxes i'll find more.

i'll get the carbs down tomorrow and see what they need. might get them fitted if i have time ( )

[royster81]

catch tank fitted and i'm well happy with how it turned out, the breather pipe exits just under the number plate and all the bodywork and tank fits without fouling .

up in the loft i got opening two boxes, one had the carbs,oil cooler and air tray and the other had HRC an over flow bottle and rear brake res. i'll put up what i don't need in the for sale section shortly.
carbs got the jets and needles put in and a spare fuel tap was HRC speced !

now to get ten minutes to fit them...

[royster81]

i've been busy over the last few days, i got time to fit the HRC carbs ( pictures to follow) and i'm very happy with them now, i've also a few other bits to get sorted, heres the pictures of the oil cooler and the brake res and over flow bottle but i've also a full hrc system.


i think they'll look well all fitted don't you ?

[Cammo]

Rhory, I think you need to fit the hrc system to this one!

Looking forward to this build.

[G-MAN]

get it sorted mate

[alexwitham]

Exhaust looks in good nick. Looks heavy mind, mild steel I'm assuming?