nc24 stators, Which one?

[spooky]

Temporary gasket made out of a weetabix box with a thin smear of blue instant gasket should hold it tight till I get a proper one,

[Neosophist]

The dark phase of the stator doesn't look too bad, they often go darker with the heat, but it looks like its actually melted? Thats bad :)

[CMSMJ1]

Nice....

I had a pic like that once upon a time!

[spooky]

The dark phase of the stator doesn't look too bad, they often go darker with the heat, but it looks like its actually melted? Thats bad :)

It must have melted as there is little blobs of gunge stuck on the inside of the flywheel. When i looked at it first i thought the flywheel was damaged but it just rubbed off when i wiped it so its all ok, thank feck. I'll take some more pics when the new one arrives,

[Neosophist]

You only need to measure the ID of the stator I think to find the difference.

4 x 8mm head bolts out and it lifts out (you need to undo the tag too, 1x philips #1) and measure the ID with a caliper etc

[spooky]

Neo, Electricx World say only two types fit , G17 = 92 mm outside diameter & G72 = 102 mm outside diameter. I have measured my one at 102 mm so looks like its the G72..I have ordered one now so if its wrong they will swap it for the other..I did ask!

[Neosophist]

Yeah thats the later one, same as the NC30. (oh which is what you have btw)

[spooky]

New gasket arrived from David silvers today and posty left a note to pick up stator from post office, will get it tomorrow, To wet and windy to work outside today anyway. I really need a garage.lol

[spooky]

Yee ha . all sorted now, 13.6 v at tick over rising to over 14 when reved up so its all working as it should.