titanium parts

Post by **porndoguk** » Sun Oct 03, 2010 4:39 pm

blodnob wrote:How do i get my avatar in the blue box ?

you have to donate £10 to the site to become a member

Post by **blodnob** » Sun Oct 03, 2010 5:29 pm

Oki koki.

banoffee · Post by **banoffee** » Sun Oct 03, 2010 7:26 pm

ibby4585 wrote:NC30 wheel spacer and axle nut

me too, depending on cost

Post by **marcus57** » Sun Oct 03, 2010 7:33 pm

banoffee wrote:
ibby4585 wrote:NC30 wheel spacer and axle nut
me too, depending on cost

Post by **blodnob** » Sun Oct 03, 2010 8:32 pm

First attempt at the nuts.
I didn't have the right size endmill for the castleations so i just drilled holes for the split pin.

The thread is bored through, machine cut and then faced off to guaruntee concentricty.

Screws on real nice like.

I'll order the right cutters to do the castleations proper.
Laters.

Post by **Dgeoff33** » Sun Oct 03, 2010 9:02 pm

Sean, it looks better with the holes instead of the castleations, only my opinion of course.

code2006 · Post by **code2006** » Sun Oct 03, 2010 9:02 pm

geoff33 wrote:Sean, it looks better with the holes instead of the castleations, only my opinion of course.

X2

Post by **Drunkn Munky** » Sun Oct 03, 2010 9:03 pm

I quite like the look of it drilled rather than standard

Post by **blodnob** » Sun Oct 03, 2010 9:04 pm

geoff33 wrote:Sean, it looks better with the holes instead of the castleations, only my opinion of course.

Glad you like it Geoff.
Cos it's yours.

Post by **Drunkn Munky** » Sun Oct 03, 2010 9:08 pm

I'll take one if there's any left, drilled please