RVF NC35 Front end on CBR NC29 - Big job?
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
CMSMJ1
- Moderators
- Posts: 7161
- Joined: Thu May 01, 2008 9:42 am
- Bike owned: NC30-No9
- Location: Chesterfield, United Kingdom
Re: RVF NC35 Front end on CBR NC29 - Big job?
Looking at the fiches.....
The entire stack of bearings, including spacers, washers, locknut and top bolt are the same part refs.
Depends on the length of stem and some fiddling with lockstops...
The entire stack of bearings, including spacers, washers, locknut and top bolt are the same part refs.
Depends on the length of stem and some fiddling with lockstops...
IMPERATOR REX ANGLORUM
The V4 is the law..
NC30 - No9 - my old mate
The V4 is the law..
NC30 - No9 - my old mate
-
Jinx
- Settled in member
- Posts: 27
- Joined: Tue Aug 17, 2010 10:21 pm
Re: RVF NC35 Front end on CBR NC29 - Big job?
I'm doing this mod to my NC29 at the moment. Just pulled apart the 29 front end and offered up the 35 and it is NOT a straight swap. The 35 stem is too short by around 10mm. There's not enought room to fit the lock nut.
Anyone know any engineering shops in Essex who'd press the stem in and out?
My 29 is from 1991 so an RRL. I don't know if the later years will be different
Anyone know any engineering shops in Essex who'd press the stem in and out?
My 29 is from 1991 so an RRL. I don't know if the later years will be different