Beat/Safest way to wire in a fuel pump?

[Drunkn Munky]

What would be the best/safest place to take power from the the fuel pump when running ram air? Im thinking a fused feed from the +12v ignition side of the fuse box or is there a better way?

[royster81]

the way agreth was told to do it when he did the ramair to his trackbike

something to do with the black wire on the rear coil and an earth

[zimm]

splice off the + to a coil (as said above) then to ground

this way if the engine stops, the pump also stops.

[Drunkn Munky]

Sounds sensible, cheers fellas

[eamer1989]

when thats the way to do it as above tony :)

i did finnaly get my Ram air working rite after messing around with the tap as it was sucking the diaphram to hard so i removed completely and sealed the breathers and working fine now :) could do with being dynoed up but it seemed to run fine at high rpm

[Spike16]

Not sure anyway is safest, I just have it off a 12v ignition live (ie rear coil live) and works fine, mbe if it was a road bike id put it on a switch aswell so its not constantly going whenever you turn the bike on? just an idea