Where is the idle cable going on nc30(sorted)but need help

[theoutsider]

I was trying to adjust a bit my nc30 as it runs like shit,played with the idle cable and it came out.I haven`t got a clue where it goes back,a picture will be helpful,also how do I set the idle without the bike being started,it starts usually very hard,if it starts.Thanks

[CMSMJ1]

You are going to have to get down and dirty with it...

Get your tank off and have a look down the left hand side - you will be able to see where the idle screws into the carbs - easy to sort out but you need ot be able to see what you are doing.

[theoutsider]

.I will give it a go now and let you know.Cheers

[theoutsider]

Cheers mate.Sorted,i saw it without the tank off,but you can see much better with it off,also the bolt was threaded so thats why it wouldnt go in easy.

[theoutsider]

My bike finnaly started after cleaning all the plugs and heat them up with the blow torch.But it runs very bad,it won`t idle without my help,it splutters,it backfires,it takes ages to start and even after it`s warm it wouldn`t start as it should.If I try to start the bike few times,I need to take the plugs out to clean them as it won`t start.All started from putting the restrictors in the carbs.Restrictors in,bike will start,after 10 min nothing(but this has been 2 months ago) without the restrictors it wouldn`t start(but it ran absolutely spotless).Could my problems be related due to dead plugs?

[Sligeach]

Could my problems be related due to dead plugs?

Highly highly highly likely
they die very easily