Page 1 of 1
Carb inlet rubbers, Which way round?
Posted: Sat Dec 27, 2008 12:36 pm
by Drunkn Munky
Does anyone have a pic showing which way round the inlet rubbers go or doesnt it matter?
NC35 by the way but 30's are probably the same
Re: Carb inlet rubbers, Which way round?
Posted: Sat Dec 27, 2008 1:05 pm
by Jon
Not familiar with NC35 ones but the my NC30 ones have writing on one side; carb and up.
The writing faces towards the carbies and the up towards the cam covers.
If yours have no writing;
There is a tapered lip on the inside of the rubbers (kind of like a funnel), the bigger opening facing towards the carbies and smaller towards the motor.
Hope this helps
jon