Hey boys!

Have a toasted reg/rec plug on my nc35 and suspect that this has been the cause of my issues. So I thought I may as well change the reg/rec while I'm at it. Bought a r6 reg/rec from ebay (99-02 5 pin model) and also new connectors/spades/wires.

So I'm ready to set this all up and do the swap but I'm a bit confused here. I have been doing some research on the forums and read that the top two wires need to be switched around for the r6 reg/rec and some didn't say it was necessary. Can anyone confirm which one is the proper way? Much rather ask then fuck anything up

1.
[+RED] [-GREEN]
[YELLOW][YELLOW][YELLOW]

2.
[-GREEN] [+RED]
[YELLOW][YELLOW][YELLOW]

So is it 1 or 2?

Much appreciated.

number 1 worked for me. i just did mine today. i toasted the starter solenoid fuse to figure this out.

If you wire it backwards you will blow the main fuse. Switch it round and you should be fine.



Here is cammos bike with an R6 Rec/Rec you can see the wire colours...