• nc23 carb proplems plz help :(

Posted: **Wed May 15, 2013 11:52 pm**

hey guys
got nc23 used to work just fine till it shut down at idle
cleaned the slow jets worked just fine
suddenly when the bike get's warm the idle increase itself
cleaned the carb ( slow jets - big jets - pilot screw. found out that there is littile spring and washer under the pilot screw that was damaged and changed them ) closed the pilot screw and turn it 2.5 turn out
now the bike when its cold idle very good
when it gets warm or hot the idle increase again so i have to adjust idle speed till it idle again
but when i touch the throttle the rpm increase and stay up
then i have to adjust idle speed again and so on

please any help cause i had enough of this bike

one last thing it used to rev to the limit makin that sound

now not

Posted: **Thu May 16, 2013 12:59 am**

bido600 wrote:hey guys
got nc23 used to work just fine till it shut down at idle
cleaned the slow jets worked just fine
suddenly when the bike get's warm the idle increase itself
cleaned the carb ( slow jets - big jets - pilot screw. found out that there is littile spring and washer under the pilot screw that was damaged and changed them ) closed the pilot screw and turn it 2.5 turn out
now the bike when its cold idle very good
when it gets warm or hot the idle increase again so i have to adjust idle speed till it idle again
but when i touch the throttle the rpm increase and stay up
then i have to adjust idle speed again and so on

please any help cause i had enough of this bike

one last thing it used to rev to the limit making that sound now not

Mate your carbs are screwed so your better of rebuilding them or getting new ones my friends fzr400 has the exact same problem as you and we have done absolutely everything to fix them with no success so he is going to buy new ones! hope this helps!

Posted: **Thu May 16, 2013 1:52 pm**

check your throttle cable isnt sticking. In addition spray some carb cleaner or similar around the base of the carbs and see if the revs alter - that would indicate an air leak, check they are seated properly.

It might be an idea to balance them and see if it helps at all.

Posted: **Thu May 16, 2013 4:57 pm**

ZXESAS
i did the rebuild and still the same prob

the prob that the carbs here are too expensive

Posted: **Thu May 16, 2013 4:59 pm**

The Novice
checked no air leaks
all the cables are good

the only thing i didnt do the balance or sync the carb
but its not balanced could it do this ?

Posted: **Sat May 18, 2013 9:24 am**

bido600 wrote:The Novice
checked no air leaks
all the cables are good

the only thing i didnt do the balance or sync the carb
but its not balanced could it do this ?

Balance the carbs as well it might be the problem

nc23 carb proplems plz help :(

nc23 carb proplems plz help :(

Re: nc23 carb proplems plz help :(

Re: nc23 carb proplems plz help :(

Re: nc23 carb proplems plz help :(

Re: nc23 carb proplems plz help :(

Re: nc23 carb proplems plz help :(