Hi all,

Apologies for the some what dim question but how do you tighten up the clamps on rubbers for the front carbs? I have looked in the Haynes manual but it doesn't seem to specify how you do them up...

I can obviously do the clamps up on the rear cylinder because there is easy access so no problems there!

Hope this makes sense and cheers for any help offered.

The carb jetting document in this link shows how to access them, you simply need a long philips head screwdriver: http://www.400greybike.com/docs.htm

Thanks very much! The Haynes manual doesn't say anything about taking the lower fairings off to get the front carbs off!!