I am looking to get mental and drill my fairings to allow more cooling air over and around the engine bay and also my currently side mounted oil cooler.

What do you reckon? Form or function? My fairings are not plastic OE so am not bothered about getting drill happy with them and I will likely to it to the track fairings first to see what it performs like.

Anyone got any other drilled fairing pics and any thoughts about whether it works or not?

At least drill in a straight line...

LOL - I noticed that too...

Saying that my DT's are not so bad these days and I will tape the lines on and drill them properly..

very cool indeed (excuse the pun),but you knew i was going to say that anyway

i was told if something is done neatly and done right ,anything can look good.


i'm seriously considering this is a head anywhere near the red on the guage

I'm not sure about function wise, but think it would look really good if done properly.

Uber cool.

Who's is that bike?

fumb wrote:Uber cool.

Who's is that bike?

no idea....but it is a nice moto for sure.

I can see my no9 becoming a rothmans bike a la that pic.
Since I did my NR scheme and it was copied it seems like I was abused or fiddled...you know what I mean?

CMSMJ1 wrote:

fumb wrote:Uber cool.

Who's is that bike?

no idea....but it is a nice moto for sure.

I can see my no9 becoming a rothmans bike a la that pic.
Since I did my NR scheme and it was copied it seems like I was abused or fiddled...you know what I mean?

Where did you get the pic from?

Is it an NC30 with NC35 forks? That front looks like NC30, maybe home made single head light conversion?. It looks pretty good either way.

nah iv seen that picture before and its a rc30

CMSMJ1 wrote:Anyone got any other drilled fairing pics and any thoughts about whether it works or not?

One word.

Fireblade

Cool as feck.

Druid