As title says, does anyone know of a jack up kit for the 23/29?

Being 6 foot 3 im wanting to get the back end a bit higher, if there is a jack up kit would be brilliant or is the easiest way going to be a cbr600 shock?

Cheers
Adam

petrolhead19 wrote:As title says, does anyone know of a jack up kit for the 23/29?

Being 6 foot 3 im wanting to get the back end a bit higher, if there is a jack up kit would be brilliant or is the easiest way going to be a cbr600 shock?

Cheers
Adam

No. You need longer shock.

You could try Hyperpro. I did the brochure layouts for Performance Parts and the Hyperpro fitment list was vast with loads of random models. I think the jack up kits were about £30 off the top of my head. Give them a ring and see what they can get.

http://www.performanceparts-ltd.com/
01788 869 100

ianw wrote:You could try Hyperpro. I did the brochure layouts for Performance Parts and the Hyperpro fitment list was vast with loads of random models. I think the jack up kits were about £30 off the top of my head. Give them a ring and see what they can get.

http://www.performanceparts-ltd.com/
01788 869 100

Cheers mate will check them out

If you can put a pic of the part up for me to see we could make something that'd work.

This is a NC23 linkage:

with the hole filled with weld...
The other part of the linkage is cast aluminum with needle roller bearings, and un-mod-able

PARUS wrote:No. You need longer shock.

That all depends on how much he wants to raise the rear. You can raise up to around 2" on the OE shock by changing the bones.

trickyd400 wrote:This is a NC23 linkage:

with the hole filled with weld...
The other part of the linkage is cast aluminum with needle roller bearings, and un-mod-able

Thanks for the pic.

Are they bearings in that linkage, or is it a rubber mounted bush? I can't tell, sorry.

I'm pretty sure we could manufacture something that would include a range of adjustability in it. Has anyone got a spare they could, well, spare for me to nosey at?

Kayla850 wrote:

trickyd400 wrote:This is a NC23 linkage:

with the hole filled with weld...
The other part of the linkage is cast aluminum with needle roller bearings, and un-mod-able

Thanks for the pic.

Are they bearings in that linkage, or is it a rubber mounted bush? I can't tell, sorry.

I'm pretty sure we could manufacture something that would include a range of adjustability in it. Has anyone got a spare they could, well, spare for me to nosey at?

I have a spare nc23 shock linkage and bones etc

Yes Kayla, it's a rubber bush. I could send you one, just say the word!