Head work q's & Skimmed heads and shims EOI
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Lane
- Site Supporter
- Posts: 127
- Joined: Sun May 29, 2011 11:34 am
- Bike owned: MC21,MC22,NC35's,VJ22
- Location: Sydney, Australia
Head work q's & Skimmed heads and shims EOI
G'day lads,
I have the NC30 engine out of my bike and the heads are coming off and will be receiving a clean up.
While i've got it apart i want to clean up the casting marks and knife edge the intake and exhaust splitters and polish the exhaust ports.
I will inspect the valve seats and do some light lapping of the valves too.
Any comments on this work from others who have done it?
Going to skim the heads for extra comression so, I'm getting a quote on laser cut shims to lift cam towers etc from here:
Uploaded with ImageShack.us
In that thread i noticed quite a few people expressed interest in the shim set,
So while i'm at it, who would be keen for a set?
I was thinking around 0.3mm or 0.4mm perhaps?
I have the NC30 engine out of my bike and the heads are coming off and will be receiving a clean up.
While i've got it apart i want to clean up the casting marks and knife edge the intake and exhaust splitters and polish the exhaust ports.
I will inspect the valve seats and do some light lapping of the valves too.
Any comments on this work from others who have done it?
Going to skim the heads for extra comression so, I'm getting a quote on laser cut shims to lift cam towers etc from here:
Uploaded with ImageShack.us
In that thread i noticed quite a few people expressed interest in the shim set,
So while i'm at it, who would be keen for a set?
I was thinking around 0.3mm or 0.4mm perhaps?