Page 1 of 1
NC35 rear single sided paddock stand
Posted: Sun Jul 03, 2011 4:15 pm
by dan1978
I ordered a rear paddock stand for my NC35 recently. The spindle that was included doesn't fit my bike. I was wondering what size spindle I need for it? I think the make of the paddock stand is bikeit.
Re: NC35 rear single sided paddock stand
Posted: Mon Jul 04, 2011 12:53 am
by Ben_OB1
From another company's website, the pin dimensions you need are as follows (I've just been through this same drama):
Length = 75mm
Diameter = 28.4mm
Hope this gets you out of trouble.
Ben.
Re: NC35 rear single sided paddock stand
Posted: Mon Jul 04, 2011 9:29 am
by dan1978
Ok, thanks Ben.
Re: NC35 rear single sided paddock stand
Posted: Mon Jul 04, 2011 7:21 pm
by mick.mh2racing
I thought diameter was the same as NC30, and that's 31.5mm.
Re: NC35 rear single sided paddock stand
Posted: Tue Jul 05, 2011 12:20 am
by Ben_OB1
It is possible that I am wrong but I was referencing the Constands catalogue:
http://www.bs-motoparts.com/Paddock_Sta ... 8_4956.htm
Please correct me if I am wrong.
Ben.
Re: NC35 rear single sided paddock stand
Posted: Tue Jul 05, 2011 8:31 am
by Cru Jones
Mick is correct. A lot of stand companies try to use a smaller diameter pin because it fits more Hondas (e.g. VFRs and the NT650), but the correct diameter is ~31.5mm. I think only the NC30/35, RC30/45 use the 31.5mm pin, but could be wrong (can't remember the RS250 and MC28 diameters off the top of my head - they may use it as well).