just put on a set of dimond rearsets
brake side however the lever is sitting far to low for me to reach i have fully adjust the screw to make it as low as it will go but still no luck any help?

When you say you've adjusted it do you mean you shortened or lengthened the connecting rod?
If not that's the way, but a picture would make it easier to understand.

I to are having this problem I'll get a Pic up shortly

Here is a couple of pics I think your after.





The lever does sit really low at full adjustment.

Yer does seem a bit low, but for me that would be better as i never use the back brake

Yeah thats the proplem mine is even lower than that though i have the original joint which is used with the standard sets

mine look like that

looks like there is still some room for adjustment there.

thats an example of found of someone else with the proplem mines a tiny bit better but not good enougeh

I'm going to give this a coat of thinking about tomorrow while I'm doing some more work on mine because there must be a better way of doing this.