help rearsets

joshmega · Post by **joshmega** » Fri Jun 24, 2011 6:56 pm

just put on a set of dimond rearsets
brake side however the lever is sitting far to low for me to reach i have fully adjust the screw to make it as low as it will go but still no luck any help?

Post by **mick.mh2racing** » Sat Jun 25, 2011 1:02 pm

When you say you've adjusted it do you mean you shortened or lengthened the connecting rod?
If not that's the way, but a picture would make it easier to understand.

Post by **Jamboy** » Sat Jun 25, 2011 3:50 pm

I to are having this problem I'll get a Pic up shortly

Post by **Jamboy** » Sat Jun 25, 2011 4:15 pm

Here is a couple of pics I think your after.

The lever does sit really low at full adjustment.

Post by **skinnydog0_0** » Sat Jun 25, 2011 5:05 pm

Yer does seem a bit low, but for me that would be better as i never use the back brake

joshmega · Post by **joshmega** » Sat Jun 25, 2011 5:37 pm

Yeah thats the proplem mine is even lower than that though i have the original joint which is used with the standard sets

joshmega · Post by **joshmega** » Sat Jun 25, 2011 10:00 pm

mine look like that

Post by **Jamboy** » Sat Jun 25, 2011 10:03 pm

looks like there is still some room for adjustment there.

joshmega · Post by **joshmega** » Sat Jun 25, 2011 10:07 pm

thats an example of found of someone else with the proplem mines a tiny bit better but not good enougeh

Post by **Jamboy** » Sat Jun 25, 2011 10:08 pm

I'm going to give this a coat of thinking about tomorrow while I'm doing some more work on mine because there must be a better way of doing this.

help rearsets

help rearsets

Re: help rearsets

Re: help rearsets

Re: help rearsets

Re: help rearsets

Re: help rearsets

Re: help rearsets

Re: help rearsets

Re: help rearsets

Re: help rearsets