Taken the spindle out but have that threaded cap in, how do I remove this?

Ta!

The one with the castellations or the large allen key? Have a look at the Workshop manual mate..

CMSMJ1 wrote:The one with the castellations or the large allen key? Have a look at the Workshop manual mate..

if memery serve right is a 13 or a 14mm allen key which i didnt have so i used a bolt 13 or 14mm, locked two 13mm m8 nuts off on the thread then used a 13mm spanner.

perfect homemade too :)

14mm then - I got a large sump key that was right! Halfrauds FTMFW innit.

porndoguk wrote:

CMSMJ1 wrote:The one with the castellations or the large allen key? Have a look at the Workshop manual mate..

if memery serve right is a 13 or a 14mm allen key which i didnt have so i used a bolt 13 or 14mm, locked two 13mm m8 nuts off on the thread then used a 13mm spanner.

perfect homemade too :)

Genius, idea copied and used successfully! One swingarm removed!!

Why Thank you tom,

my dad said the same thing when i did it?

i got a proffesional set of high tensile allen keys and the biggest i had was a 12mm and ive never used it,

so as i said used the head of a bolt and improvised :)

smart arse