nc30 clutch!!!

[dannyboy]

hi all i noticed the other day my clutch feels soo shit so i took to my cusins garage n got him to have a goose. n my steel plates n friction plates are warped n maybe friction plates broken. sooooo more exspense on my bike!!!! £170 fitted???? any good???

also my speedo drive worm???? has snapped its little plastic bridges in it????? any one got one or hw much n wear for a new one????

[Sligeach]

just watch my video and do it yourself for half the price

[dannyboy]

wat vid?

[jim157]

It's stickied in the V4 section.

[CRM]

in the V4 section, which is funnily enough where this thread belongs !

[iDemonix]

I'm going to be replacing mine after I get back from my holiday in a couple of weeks, think I'm going to do a full overhaul though of springs, engine plates and friction plates. It's going to cost me a fair bit though as I'm doing all three parts, plus I need to buy a breaker bar and clutch nut unless anyone has one they want beer tokens for

[uber pikey]

I have a n intact worm drive with the cable still fitted, make me an offer unless someone can tell me what it's worth.

[vfrman]

I have a used clutch pack you can have on the cheep...

I will have to take a quick look to make sure the plates are in good condition.

[dannyboy]

thanks everyne lol

did it last night n we got the clutch of wich the steels wer worped. but the main problem was the clutch road engine bearing had disintergrated so luckly i didnt ride it anymore, as we found all the bearing race in pieces in the sump.

but we managed to make a tool to pull the bearing out without have to nock it out from the other side, then replaced so the clutch rod didnt have play in it now n the plates are replaced n now the clutch feels amazing better than we i first gt the bike :)

[lizard821000]

170 to fit plates, seems dear to me. do your self??