Some time ago i had a bros rear wheel that i
modded to fit my racebike.
I let the guy have it when i sold the bike.
I bought another but its different and wont fit.
Does anyone know what model fits
i know theyre ugly and heavy but i only
want it for my wets
thanks

How is it different to the other bros wheel?

There were two different types of wheels used, but I can't imagine they'd have changed the locating hub?



Are you sure you didn't end up with a Revere wheel or something off one of the other similar shaft drive bikes?

They don't just bolt on - thye need modding first. I have one, am away now but I'll get a pic when I am back. Could even flog it...

The Bros also came in 400 and 650, not sure if there was a difference between them in wheels or igt was just a later model that had different wheels on it..

Neosophist wrote:The Bros also came in 400 and 650, not sure if there was a difference between them in wheels or igt was just a later model that had different wheels on it..

The later one was different

The alignment/drive pins have different spacing is all. One is 85 pcd, the other 100. Just have the wheel drive pin holes drilled ($), or the hub modified ($$$$). Since the nc pins are closer to the middle of the wheel it will be fine structurally. I know of guys with Bros who go the other way with nc wheels and the pins end up out on the edge of the wheel.