• NC30 front disk bolt size?

Posted: **Thu Jun 03, 2010 10:48 pm**

I snapped one of the bolts that holds the disk in place. I drilled the bolt out but the thread needs tapping.

What size tap do i need?

Thanks.

Posted: **Fri Jun 04, 2010 9:11 am**

M6 x 1 mm. You may need to helicoil it if you can't tap a decent thread though.

Posted: **Fri Jun 04, 2010 1:02 pm**

1mm???

Posted: **Fri Jun 04, 2010 1:07 pm**

1mm is the standard pitch for a 6mm thread

BR

Neil B

Posted: **Sat Jun 05, 2010 1:02 am**

superlite wrote:M6 x 1 mm.

Thanks

Posted: **Sat Jun 05, 2010 5:16 pm**

superlite wrote:M6 x 1 mm. You may need to helicoil it if you can't tap a decent thread though.

Worked a treat today. Thanks.

Didnt have to go down the helicoil route however ive snapped another bolt

So i have to do it all over again.

NC30 front disk bolt size?