Hiya

I've just got a 3EN1 and we're (me and my boyfriend) are in the throes of taking stuff off it and putting newer stuff on. So far we've fitted a full TRX/Thundercat front end and got a TRX single seat to fit. There's a spare TRX rear end to fit too.

The front end is a mix of TRX and Thundercat parts. The yokes are TRX and fit straight into the FZR frame. The forks are Thundercat and the wheels and discs are TRX. The brakes are R6 blue spots.

The swingarm should go in fairly easily. I need to have the pivot machined down to fit the frame and have some bushes made to reduce the internal diameter to take the FZR swingarm spindle but other than that, it should go right in using all the TRX bits. The chainline appears to be there or thereabouts too

I'll take some pics and post some measurements up when we get it all together- it's in the shed in bits at the minute

Hey Kayla

Nice to hear your upgrading your bike - welcome to the forum
maybe we should get some pics sooner :)

yeah,lots and lots of pics please!!

blooming heck Kayla you dont hang about girl do you!!,

good luck with it

hipringle wrote:blooming heck Kayla you dont hang about girl do you!!,

good luck with it

Thanks We got another TRX on Friday too

You like your Yams then :)

Evilchicken0 wrote:You like your Yams then :)

Just a bit! They're brill cos so much stuff is interchangeable between different models. You can take one bike and make it something else, like Lego

Pictures, yes, lots of them!

Considered a TRX850 lump for a hybrid, not sure it's poss though........

nick wrote:Considered a TRX850 lump for a hybrid, not sure it's poss though........

I think it'd fit in the frame but the oil tank (it's a dry sump engine) would get in the way of the 3EN fuel tank so a different oil tank would be needed. I fancied trying it myself