Page 1 of 1
Service limit for front brake disk
Posted: Sat Feb 06, 2010 7:45 pm
by plodder
I've got some 3TJ discs that are a bit worn but can't find a service limit anywhere. At what thickness should they be scrapped?
Are these disks the same as FZR600 disks?
Re: Service limit for front brake disk
Posted: Sat Feb 06, 2010 9:02 pm
by hunter
The min for 4jh is 3.4mm,and i think they are the same as 400 one's but not sure.
Re: Service limit for front brake disk
Posted: Sun Feb 07, 2010 6:19 pm
by Evilchicken0
Yes - lots of the Yamaha's use 298mm disks
Re: Service limit for front brake disk
Posted: Sun Feb 07, 2010 6:45 pm
by plodder
I presume the offset is the same for all of the 298mm disks then?
Re: Service limit for front brake disk
Posted: Sun Feb 07, 2010 7:02 pm
by Motorcycle Solutions
Plodder
Standard front Disc 4mm
prolites i beleive 4.5mm
this is for all fzr400's
Re: Service limit for front brake disk
Posted: Thu Feb 25, 2010 5:41 am
by sparkles
Motorcycle Solutions wrote:Plodder
Standard front Disc 4mm
prolites i beleive 4.5mm
this is for all fzr400's
How about fzr6's ?
Re: Service limit for front brake disk
Posted: Thu Feb 25, 2010 1:22 pm
by Evilchicken0
FZR 600 and/or (early) Fazer ??? They're essentially the same disk.
Things changed with the later wheels, the hole in the middle is bigger ... a good example would be the R6