Hi,

Can someone tell where to cut the pipe on my exhaust so that i can fit my blueflame can?? the pipe has already been cut but much higher up near to the rear footrests. i tried putting it on the end of that cut but two things happen.
1. the blueflame end can goes way past the indicators and numberplate (looks ridiculous) and fouls the the foot rests
2. the link pipe adaptor i have got doesnt fit. it is far to large for the exhaust.

i have measured the two bits the exhaust diameter is 50-54cm and my link adaptor is 62-63. these are outer diameters. if i cut the exhaust further down does exhaust diameter get bigger??

any info would be great!! piccys would be really helpful!!!!

Ta
Kris

pictures of what you have would help probably? I can visualise it but youll probably get a better answer if you include a pic :)

i cant at the mo bike is stored in a lock up. will try and take some in afew days! Didnt you have this problem a few weeks ago??

cut mine recently - approx 10mm from the weld

ordered my can to be 400mm so that it exited just before the number plate

pic:

are you sure 10mm from the weld? looks more!! Is that the weld under the heat deflector?? i take it then i just measure the end can and cut the pipe where i want the end can to finish yeah? do you remember the dimensions of the link adaptor?? sorry i am useless. its all very new to me!!

Ta
Kris

this might help

your link adaptor is too big you need one that sleeves down to 50-52mm as like the one on Banoffee's bike.

That link looks like it is off a much larger bike and is too long...

sorry im confused now, i havent shown the link adaptor in any photos all i have shown is where the exhaust pipe has been cut! my link adaptor is shorter in length than banofee's could someone clarify the diamater for the original exhaust and the link adaptor needed!!

ta
Kris