Just read through this and what an awesome read it was, great job there Rhory, going back to a previous comment, a lot of people talk the talk, but you have showed some serious balls and walked the walk!
Well done mate.

cheers fella,
i still have this on the grey/black bike and i've only had 1 or 2 moments when i thought the bike was getting far to hot and i should maybe pull over for 10/15 minutes.
i think on the track it would be good but for the road i'll just stick with the standard rad and fan.

i never got the chance to try out a bigger rad or cleaner rad but no doubt if i had a better condition lower rad it work compliment the oil cooler no end.

as far as i know only one other has done this mod...

royster81 wrote:
as far as i know only one other has done this mod...

Is it only Mike Lohemeyer who did the akhara web pages?

I fitted a cooler too....but not the same way as you did

CMSMJ1 wrote:

royster81 wrote:
as far as i know only one other has done this mod...

Is it only Mike Lohemeyer who did the akhara web pages?

I fitted a cooler too....but not the same way as you did

Just out of curiosity, is there an explanation why the JDM 30 didn't have an oil cooler?

My 24 has one and the UK spec 30 has one too.

royster81 wrote:cheers fella,

as far as i know only one other has done this mod...

And as of yet I still haven't fired the bike up with it on and all I did was fit the bits that you sent me

I think I still have a set of the NC30 UK spec oil cooler pipe work in the garage if they'd be of use to anyone trying these sorts of things?

mattUKNC wrote:I think I still have a set of the NC30 UK spec oil cooler pipe work in the garage if they'd be of use to anyone trying these sorts of things?

I'd like to try and retrofit the UK pump and pipes to my next motor... I'd donate to your "what to get next" fund for them pipes mate

CMSMJ1 wrote:

mattUKNC wrote:I think I still have a set of the NC30 UK spec oil cooler pipe work in the garage if they'd be of use to anyone trying these sorts of things?

I'd like to try and retrofit the UK pump and pipes to my next motor... I'd donate to your "what to get next" fund for them pipes mate

They are all yours Mark, PM your details and I'll get them sent off.

and it just so happens i have a uk pump mate ...

does anyone have the uk microfiche for the nc30. i'd be intersted in knowing the part numbers of the nc30 oil pump / block etc.