Received all other stuff.
1. Innovate LC-1 Bosch 02 Sensor and Lambda. Really this is good thing ever for bike without fuel injection, because easy allow you to detect are you running LEAN or RICH. You can trace air\fuel ration (AFR) with laptop or gauge.


2. Desided to change NC29 temperature sensor with MyChron. Because one-wire temp sensor give a lot of noise and not desirable for the fuel injection.


3. Knock sensor from CBR600RR. Look like you can use from car, this is one little bit smaller.


4. Intake air temperature sensor. From CBR600RR


5. Fuel pump with fuel level sensor. Also from CBR600RR. Need to fabricate fastener to fit this to NC29 fuel tank.

6. Bought full wiring from CBR600RR, because it cheaper than getting individual connector for other stuff. And it also had small automotive relays - I think it can be also use in project to save some room.


7. Undertail unit with LED turn signal.


8. Added LC-1 Innovate o2 sensor\controler circuit to wiring diagramm.
http://www.moto.kiev.ua/users/parus/CBR ... g_loom.tif

What do you think about such type of RamAir ?


Fabricate simple model of the ram air I'm planning to use. Of course, there is no dirrect airflow like in HRC airbox, but should be not big difference and you will be able to use stock airbox, and do not need to looking another place for HT coils.

This is just model, will be done from carbon soon.

So, noone having any idea about such ram air ?

Busy with wiring for now. When all wiring will be done - make one more video with bad english.

1. Updated wiring loom.
- used CBR600 Fuse box, instead of using many separate fuses and automotive relay.
- added bank angel sensor

PS: Don't be sirprised when I join different color wire, I'm trying to use CBR600RR 07 wiring, but sometimes same wire has different color.



TIFF-file: http://www.moto.kiev.ua/users/parus/CBR ... g_loom.tif

IAC Stepper motor controler for Microsquirt. Hope to test it soon.

http://www.youtube.com/watch?v=MhoLST4WaS8.

PARUS wrote:http://www.youtube.com/watch?v=Wj-JSp6C81s

amorti wrote:

PARUS wrote:http://www.youtube.com/watch?v=Wj-JSp6C81s

Guys (not from this forum),

Asked me to show how and where I fit Microsquirt, Mychron, PWM Controler. Just made quick video that all done inside of subframe.

Mychron speed sensor http://www.youtube.com/watch?v=zAQPQ2brR9o

Camshafr position sensor http://www.youtube.com/watch?v=b1GuMd_Bhak

Fuel pump adaptor http://www.youtube.com/watch?v=vaq3NUxHKxc

Sorry, all in russian. To lazy to make both in russian and in english.