CMSMJ1, do you have any pictures of the mesh filter please?

Alreet Gonzo

I use the base for the usual filter and I have 3 sheets of HRC foam in there. I'll have a squizz through my pics and see what's what.

It is a basic chop and hack up job. Not sure it does my motor much good..but the bike works lovely with it

Found this one too

From
viewtopic.php?f=24&t=8510&start=50#p81711

Thats an NC30 setup - the 35 "should" use the HRC airbox and filter.

I reckon that mesh setup looks wicked though..

thanks again for the info, by "should use" does that mean I could have a similar NC30 setup (ie in the picture above)?

CMSMJ1 wrote:Thats an NC30 setup - the 35 "should" use the HRC airbox and filter.

I reckon that mesh setup looks wicked though..

Yes, the '30 was setup to run open carbs where the '35 setup included an airbox in the kit list.

A few people on here have modded their carbs to '30 HRC spec. I just sold some..

Cammo has some, Indiaguy I think too...and Martin as well..and Royster if I have my brains working.

Can you run the NC35 HRC spec ones in an open configuration?

gonzothegreat wrote:Can you run the NC35 HRC spec ones in an open configuration?

No, its designed to work with a airbox,

thanks, that's what I wanted to know

Drunkn Munky wrote:

gonzothegreat wrote:Can you run the NC35 HRC spec ones in an open configuration?

No, its designed to work with a airbox,

http://www.youtube.com/watch?v=ZjAPE_qtoo4
A little bit in on the vid you can see my R6 filter, just about a perfect fit. I think it's a BMC.