They are going on the OKI bike then a few other tweaks and it's finished!

Red/black will be finished and sold at the end of the month, then start to strip the 1st uk bike! Send the panels off for work and start again.

Kris

Looking forward to seeing the gold dymags. Should be the icing on the cake for the Oki bike.

Cheers Jim, yeah I must admit I am looking forward to getting them on need to make a decision on tyre size and make!!

Kris

Size wise you might be best going for a 160 rear kris, just measured your rim and its 6 inch wide so not sure how a 150 profile will look.

Just picked up your wheels, got fed up with waiting and the excuses so going to do them myself

Fucking hell is it 6 inches wide!! I'm going to struggle for clearance aren't I??

What width is your Pvm rear?

Kris

Thats what i thought, theres no markings on the wheel so measured it from rim edge to edge, is this right? it measures a shade under 6"

I got a feeling my PVM is 5.5 although i'll have to check

Hmm! That's worrying but it come off a nc35 racebike so should go on!

Not sure where they take the measurement from! Rim to rim or inner lip!

I need to check that!

ibby4585 wrote:Haha, big mouth Jas!!

Yes I have some Dymags, 5spoke ones, currently with Tony getting the HRC gold treatment!!

Kris

Oops, I am sorry... Never ment to do this

Hhhm, 6 inch width? Will this fit without any influence on clearance and on the handling when cornering? On the "old" forum someone tried it too with a nice rear Marvic wheel (that came off an RC30) and it did not have enough clearance. Also, another member tried it with an RC40 (!) rear wheel...(yes, from the mighty rare NR750!), but cannot remember the issues he had with it when fitting.

ibby4585 wrote:Not sure where they take the measurement from! Rim to rim or inner lip!

Either way that's one wide arse rear wheel!

If it came off an rvf it should go on...

Yeh it came off a race nc35. Slightly concerned now though!
Just going to email the chap!

Kris