yes mate they JUST fit and no more.

thanks chaps!

Not done a great deal as ive been collecting bits to do a lot of work in one go. Ive managed to fit the maxton shock and set it properly for my weight, after lots help on fitting the TSR system ive managed to fit it so it just passes the indicators, Back wheel on with a new disc and pads. and a lot of cleaningQQ
What do you think??







ive just managed to buy this bit of swanky kit too!! Gixxer stator, flywheel and nice cover!!



found a pic of this too, hopefully mine might be as good!!

Kris, looks tidy with this TSR system ( ) But have you tried it with the rear seat panels all fitted on the bike??

I am not sure if the "new" angle of heat bend can hanger plates will make enough space left for the undersides of the rear seat panels...it might touch the panels despite the idea of free up the indicators.

micpec wrote:Kris, looks tidy with this TSR system ( ) But have you tried it with the rear seat panels all fitted on the bike??

I am not sure if the "new" angle of heat bend can hanger plates will make enough space left for the undersides of the rear seat panels...it might touch the panels despite the idea of free up the indicators.

Yeah ive measured my other seat unit and its touch and go to be honest, so im just going to take the other rvf seat unit off and try it tomorrow, its not too much of a problem as i am going to get slim indicators.

will let you know tomorrow

did you get the flywhell from flea bay? was watching it lastr night and tempted by it.then i remembered that i havnt ridden the bike for three weeks because i need tyres and some clutch plates.
that exhaust system looks the absolute sex.

Jas,

just tried my other seat unit and the brackets are about half inch too high, so not too much of a problem as i was going to take the cans off anyway when i fitted the fresh paintwork . i want the cans nice and close but not too close rhat they will melt the fibreglass and paintwork!!

Liking the grey/black twin stack bike... superb work.

Right lots of work done, but not much of it is visual!! Carbs off today fitted an RO needle kit. Old forks off, new GF race forks with progressive springs on! Coerce front hugger fitted, I really like the look of it, will like to hear your views on that?? And fitted the excellent Gixxer stator, flywheel and cover conversion kit, WOW what a difference the throttle is instant, even on the stand!! Very impressed!!

Looking trick as