Page 12 of 18

Re: Can you see what it is yet

Posted: Fri Sep 20, 2013 12:58 am
by Morespeedvicar
Looks good that dude.

Re: Can you see what it is yet

Posted: Wed Jan 15, 2014 11:29 am
by willandrip
This topic required a bump and an update from Boris ! ;)

Re: Can you see what it is yet

Posted: Wed Jan 15, 2014 1:15 pm
by Evilchicken0
I polished it a bit last night.
I had just oiled, put the top camchain guide on and fitted the tensioner to the 660.

Re: Can you see what it is yet

Posted: Tue Feb 18, 2014 9:36 pm
by chris6409
Evilchicken0 wrote:Just to take stock then

Image Image Image

Image Image

so I'm kinda onto the plastics, time to choose

Image

Now a little warning: I just kinda knicked myself getting some stickers off the tail fairings, the 3TJ red is almost an exact match for blood ... the unoxygenated type from my thumb anyway ... careful with those razor blades
I see youve got lots of fairing there il love a top fairing and a chain guide

Re: Can you see what it is yet

Posted: Tue Feb 18, 2014 10:08 pm
by Evilchicken0
I thought your bike had a top fairing ?

Re: Can you see what it is yet

Posted: Wed Feb 19, 2014 7:59 am
by chris6409
Evilchicken0 wrote:Cold huh and the days are short

I've been on the lookout for some downpipes since I got this bike so when a rusty set turned up on the bay I bit the bullet and bought them.

Image Image

The first job was to get the worst of the rust off them, I used a brass wheel on a slow drill and then gave them a coat of rust killer.

Image Image

The next weekend I used a fine grit paper with my Mouse palm sander

Image Image

And another coat of rust killer

Image Image

I missed the light or it was raining so I had to wait another week before I painted them

Image Image

I't not the best set in the world but they'll at least be servicable.
Surely there is a hero who could copy the downpipes in stainless and cut and weld the exup onto them to make new forever shiney 3tj downpipes :D

Re: Can you see what it is yet

Posted: Wed Feb 19, 2014 8:02 am
by chris6409
About the tank rust ive got abit of minor rust in mine is it worth getting the acid out

Re: Can you see what it is yet

Posted: Wed Feb 19, 2014 9:25 am
by Evilchicken0
If you have the acid then maybe - depending on how much there is. Otherwise probably not.
The 3TJ tank has a seam on the bottom so theres a bit on each side that doesn't drain when the tank's on the bike. If water gets in it sits in that bit because it's heavier than petrol, and rusts it. Make sure your tank dosen't have any water in - use a torch and see if there's anything in it.

Re: Can you see what it is yet

Posted: Wed Feb 19, 2014 10:50 am
by chris6409
There the smallest amount of liquid in it but it hums of petrol ive tryed to get the last out but like you said its in a place to hard to reach i might try lowering a long pieace of rag in to soak it up

Re: Can you see what it is yet

Posted: Wed Feb 19, 2014 11:44 am
by Evilchicken0
It's a bugger innit :grin:

Use a long piece so you don't drop it into the tank like I did. Or you can stick a hair dryer in the top of the tank