Page 2 of 2
Re: Got my bike a pressie, but how do I fit it? (Rad overflow)
Posted: Mon Dec 08, 2008 10:19 am
by DAC
Just to finish off, I found this picture on my old PC at the weekend. It came from this forum many moons ago, don't know who posted it, so can't pass on any royalties.
Regards,
Dave.
Re: Got my bike a pressie, but how do I fit it? (Rad overflow)
Posted: Mon Dec 08, 2008 3:54 pm
by oliherst
Hahaha I just want to say, not only is that very helpful but it is also TOTALLY AWESOME :D :D
Re: Got my bike a pressie, but how do I fit it? (Rad overflow)
Posted: Wed Dec 10, 2008 11:26 am
by jowyvfr
Pretty obvious who posted that originally......
:D
Re: Got my bike a pressie, but how do I fit it? (Rad overflow)
Posted: Mon Dec 15, 2008 4:30 pm
by oliherst
hahahahaaaaaa ok call me dumb, but I totally missed the point of this mod, and have just worked it out.
For ages I was looking at my bike and this thread and my haynes manual trying to work out why I couldn't work it out.
The idea behind this mod is to bypass the reserviour under the seat isn't it?
Re: Got my bike a pressie, but how do I fit it? (Rad overflow)
Posted: Mon Dec 15, 2008 4:39 pm
by Spike16
not quite bypass, more like replace, it also means you dont have to remove the tail to check, refill coolant and...err its says HRC
