Sounds fooking good, is it a 'well ard' finish then to do the nuts, not to chip when torquing up?
I'm interested

vfrderek wrote:Sounds fooking good, is it a 'well ard' finish then to do the nuts, not to chip when torquing up?
I'm interested

Well ill be torqueing up with insulation tape wrapped around them just incase but its should be a solid finish you only get chiping etc is the surface chromed onto was clean when they went in, ill assume after my polishing efforts they will finish off anything they deem to be errornous, i doubt theyd want complaints etc.

Get some pics up when ya done Ricksta