Page 2 of 2
Re: NC30 'fork rings'
Posted: Wed Oct 20, 2010 7:11 pm
by banoffee
Neosophist wrote:You mean the fork circlips?
They go on the fork-stantions, there should be a grove for them to go into, it stops the forks dropping out of the yokes.
When the circlip is against the yoke this is the factory height.
At least on the NC24 anyway.. should imagine it'd be the same on the 30. Not at home to check
For the circlip to be against the yoke on the NC30 that would put the fork in completely the wrong place surely?
CRM wrote:+1, stop the clipons dropping so in the grove in the forks
+1 for which option?
Re: NC30 'fork rings'
Posted: Thu Oct 21, 2010 2:04 pm
by banoffee
Now sorted
Re: NC30 'fork rings'
Posted: Thu Oct 21, 2010 4:31 pm
by Neosophist
Ah awesome :)
Never did get around to checking.. think I was thinking of an XBR not even an NC24 now that I come to think about it... my memory is like fish latley
Re: NC30 'fork rings'
Posted: Thu Oct 21, 2010 5:46 pm
by banoffee
yeah I thought that didn't sound right
Re: NC30 'fork rings'
Posted: Fri Oct 22, 2010 11:03 am
by Neosophist
Neosophist wrote:Ah awesome :)
Never did get around to checking.. think I was thinking of an XBR not even an NC24 now that I come to think about it... my memory is like fish latley
And come to think about it the circlips on the xbr go above the clipons and the clips go up to them.. god i need a holiday :D