Page 2 of 3
Re: RVF NC35 Front end on CBR NC29 - Big job?
Posted: Fri Apr 02, 2010 12:38 pm
by Gavin jap4
I have a set of OE NC35 triples for sale £200.00 deliverd UK mainland
Or we do the TYGA CNC triples with 10% discount and FREE UK mainland P&P discounted to europe
Re: RVF NC35 Front end on CBR NC29 - Big job?
Posted: Fri Apr 02, 2010 3:03 pm
by vr46
OK Thanks Gav, I am looking to see how big of a job it is first before I spend any money.
Re: RVF NC35 Front end on CBR NC29 - Big job?
Posted: Tue Apr 13, 2010 11:03 pm
by ChiefNutter
Did this thread die without any answer...or did i miss it?
Im thinking of swapping the forks on my nc29...and if the nc35's are a straight swap then i'll start looking for some on fleabay
Mark
Re: RVF NC35 Front end on CBR NC29 - Big job?
Posted: Wed Apr 14, 2010 10:09 am
by vr46
Still no answer to this thread.
It has been mentioned that it is a "bolt on" but no more detail.
I have seen it done on a few bikes, but I want to know what work is involved.
Re: RVF NC35 Front end on CBR NC29 - Big job?
Posted: Wed Apr 14, 2010 10:43 am
by Wozza
vr46 wrote:Still no answer to this thread.
It has been mentioned that it is a "bolt on" but no more detail.
I have seen it done on a few bikes, but I want to know what work is involved.
People have said you swap the whole front end so remove you NC29 forks and yokes, then fit NC35 yokes and forks. Not a big job.
Re: RVF NC35 Front end on CBR NC29 - Big job?
Posted: Wed Apr 14, 2010 12:18 pm
by ChiefNutter
Cheers wozza.....dont spose theres anyone on here thats done this swap ?
Re: RVF NC35 Front end on CBR NC29 - Big job?
Posted: Wed Apr 14, 2010 8:12 pm
by ChowderV4
So just to clarify , it's a straight swap?
I've seen parus's thread on a 07 cbr 600 front end conversion and he said that's a straight swap but if an rvf front end is the same then that's a nice cheaper option.
Re: RVF NC35 Front end on CBR NC29 - Big job?
Posted: Wed Apr 14, 2010 10:55 pm
by Wozza
PARUS wrote:It's bolt on... just remove NC29 front end and fit NC35.
Re: RVF NC35 Front end on CBR NC29 - Big job?
Posted: Wed Apr 14, 2010 11:16 pm
by ChowderV4
good good,
Re: RVF NC35 Front end on CBR NC29 - Big job?
Posted: Thu Apr 15, 2010 11:44 am
by tanuki
I hope this works for you but I just cant see it being a straight swap...
For instance on the NSR you have to have the stem from the NSR pressed into the RVF bottom Yoke and on the VFR you have to use a spacer and change the bearings..
Good luck with this and please take a load of photos as you go and do an article for the site.