Re: My NC30 is completed!
Posted: Tue Dec 15, 2009 4:44 pm
Tease 
- A ninja says it all...
http://www.400greybike.com/forum/
My NC30 is completed!
Page 2 of 2
Re: My NC30 is completed!
Posted: Tue Dec 15, 2009 6:32 pm
- A ninja says it all...Re: My NC30 is completed!
Posted: Thu Dec 17, 2009 12:45 am
ditto and 24 and zxr :'(rcv4 wrote:my 35....no where near !!!
Re: My NC30 is completed!
Posted: Fri Jan 15, 2010 5:15 pm
Sorry, kinda forgot I made this and have only today got it out the garage again!
Heres the pictures!
Unfortunate moment where fuel leaked out whilst the tank was sat upside down... Going to cost a few pennies to get redone!
And my winter fun :D
Heres the pictures!
Unfortunate moment where fuel leaked out whilst the tank was sat upside down... Going to cost a few pennies to get redone!
And my winter fun :D
Re: My NC30 is completed!
Posted: Fri Jan 15, 2010 6:32 pm
No petrol resistant lacquer on the tank? 
Theres bound to be some moments where your nozzle drips a few splashes onto the tank when your refuelling!
Looking great. Nice scheme. However, I think you should find the nearest bin and promptly launch those fork adjusters into it :D
Theres bound to be some moments where your nozzle drips a few splashes onto the tank when your refuelling!
Looking great. Nice scheme. However, I think you should find the nearest bin and promptly launch those fork adjusters into it :D
Re: My NC30 is completed!
Posted: Fri Jan 15, 2010 11:26 pm
nice job....clean and tidy.
Re: My NC30 is completed!
Posted: Sat Jan 16, 2010 8:10 pm
Im not sure whats on the tank to be honest, was done at a bike respray/restoration garage though....
I think its just a case of it having been upside down overnight and the fuel has actually got in from under the paint... Ive tried pushing the air out, and it does work to an extent, but realistically its not going to be sealed afterwards and just keep coming back..
I think its just a case of it having been upside down overnight and the fuel has actually got in from under the paint... Ive tried pushing the air out, and it does work to an extent, but realistically its not going to be sealed afterwards and just keep coming back..