clutch cover gasket NC29

Seomat · Post by **Seomat** » Tue Oct 20, 2009 7:35 pm

Does anybody know if I can use the clutch cover gasket of any other model? I already scratched of the original and hope to sell the bike on saturday. Due to this I have to buy an aftermarket gasket an they don't sell NC29 parts here in germany.

Thanks for your support

Waza4 · Post by **Waza4** » Tue Oct 20, 2009 8:52 pm

WEMOTO post out on the same day.

PARUS · Post by **PARUS** » Tue Oct 20, 2009 9:13 pm

davidsilver also sell them or from ebay http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... K:MEWAX:IT

Post by **Wozza** » Tue Oct 20, 2009 9:48 pm

Graeme France may be willing to send something like a gasket to Germany? Worth asking.

Seomat · Post by **Seomat** » Wed Oct 21, 2009 5:23 am

Than you folks,

Greame said, it is only NC29 and nothing else. So I have to do something marvelous - like cutting one out of a piece of gasket-paper.

Post by **greggo** » Wed Oct 21, 2009 5:44 am

You crazy young fellas. I can't imagine 'cutting' one, with scissors, out of gasket paper.

You just need gasket paper, a ball peen (peen?!) hammer and a hole punch.

Use the hole punch to make two holes to mount your gasket paper on the locating dowels on the engine, then go round the edges of the crank case with the ball end of your hammer. The edge of the case will do all the cutting and it will fit like a glove.

Made quite a few like this when I was riding two smokes.

clutch cover gasket NC29

clutch cover gasket NC29

Re: clutch cover gasket NC29

Re: clutch cover gasket NC29

Re: clutch cover gasket NC29

Re: clutch cover gasket NC29

Re: clutch cover gasket NC29