doing my head in.
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Settled in member
- Posts: 28
- Joined: Sun Oct 04, 2009 7:55 pm
- Bike owned: too many to list
doing my head in.
any body know of a good cheap bike mechanic in the leeds area that may come to me ? no van for transport. got a spark got. tried easy start no joy ! with tank off and a clear tube full of fuel when turning it over it doesnt pull the fuel in??? this is with air box top off. had carbs off n jets out once. w.t.f. !! ready for burning it. !!! or any ideas ?
-
- Settled in member
- Posts: 168
- Joined: Sat Jun 20, 2009 9:31 pm
Re: doing my head in.
Airlock ? maybe
-
- Settled in member
- Posts: 28
- Joined: Sun Oct 04, 2009 7:55 pm
- Bike owned: too many to list
Re: doing my head in.
scrap that just gone in garage for a fag n fired it up n it run !!!!!!!!!!!!!!! but only on the back cylinders ? how easy are the plugs to get out to check at the front ? 

-
- Moderators
- Posts: 8172
- Joined: Fri Jul 04, 2008 1:01 pm
- Bike owned: CBR954
Re: doing my head in.
Fiddley as the rads etc are in the way but its do-able.Dodgy Roj wrote:scrap that just gone in garage for a fag n fired it up n it run !!!!!!!!!!!!!!! but only on the back cylinders ? how easy are the plugs to get out to check at the front ?
xivlia wrote:i dont go fast on this bike so really do not need a rear brake.. /
vic-vtrvfr wrote:Ask xivlia for help, he's tackled just about every problem u could think of...
-
- Familiar Member
- Posts: 315
- Joined: Sun May 25, 2008 10:41 am
- Bike owned: '30
- Location: Durban, RSA
Re: doing my head in.
Drain the rads from the water pump on the left hand side, then loosen the upper rad right hand hose, and undo the rad fasteners, then drop them and you can access the front plugs.. Just dont over tighten them once theyre cleaned and put back in